CHARACTERISTICS AND USES
1. Features:
ENPOSS Power Saving Equipment (FORCE) is manufactured by ENPOSS Inc (Korea). FORCE’s technology is based on the patented electromagnetic mixture EMF6 and EMF7 to improve current and significantly reduce power consumption.

When the device is installed in the electrical system, there will be no effect on the operation of the equipment on the system.

The device is light in weight and compact in size, easy to install

2. Uses

FORCE is a good system in terms of energy savings, savings are achieved by improving the structure of the current, providing stability, higher current efficiency and as a consequence reduced current losses. , increasing the durability of equipment and facilities.

The greatest economic efficiency is achieved when the system is connected to multiple load devices at the same time, where a wide range of energy consuming devices (motors, air conditioners, lighting, computers) are used. , television, radio and other electrical equipment, etc.), which causes the current to vary greatly. In some

In the case, especially when using many outdated equipment, energy savings can be up to 20%.

If the FORCE is connected to only 1 load device, such as a motor, a minimum savings of about 2-3%

In a complex of devices, in which many computers and office equipment are used, many machines produce. By reducing the number of harmful negative ions in the electrical current FORCE prevents harmful elements to computers and electronic systems early on resulting in much greater savings in the long run.

Economical features of ENPOSS:

* Improved power quality

* System safety due to parallel mounting

* Saving rate 5%~17% depending on the installed load

* Even more effective for those who run too much or run too much

Figure 1: Single phase circuit

Figure 2: 3-phase circuit

INSTALLATION INSTRUCTIONS

Installing the ENPOSS device is very simple, each unit has an output wire to connect to the circuit. Normally, the device will be installed on the output terminals of the total MCB/MCCB of the electrical cabinet. The equipment is mounted for each phase and is independent of the phases. Installation of an entire EPOSS system takes about 15~45 minutes depending on the case.

Figure 3: Connection diagram

WARRANTY AND MAINTENANCE

The device will be warranted for 8 years, warranty will be issued from the manufacturer

In the process of using the device, there is no need to maintain, but pay attention to check and keep the connector clean and dry